Rust treatments last a little longer but risk staining the tub. Once the tub starts rusting like this, you can only scrape and clean and dry it to best effect. Should look very pro not "goopy" or "lumpy". Be sure it more than covers at 45 degrees the tub and well over the rust area and also up the tile wall. It should look like a smooth fine welding seam. Do a smooth caulk job around the tub like you see pros do on windows. After clean and dry, cut the tip at 90 degrees and make it large. The one in the red squeeze tube has silicone in it and is a bit better. City Mill carries lousy tub and tub and tile caulking. Had a zillion apartments in Hawaii for decades and this was a constant problem. Apparently that isn't too uncommon out here. Due to a great stroke of luck, there wasn't any mold because apparently the tub's bottom is open to the bottom of the house, so it was continuously vented. I only looked into it because I heard dripping from behind the tub one day. it was just an open hole to outside of the tub beneath the spout. In the tub alone, I found out a few months back that the overflow connection wasn't actually connected to anything. Some more detail: this house was a rental for about 20 years, and we're periodically finding out just how "handy" the handyman was who "fixed up" the place before the previous owners sold it to us. This website doesn't appear to provide a solid way forward, but one person states a rust converter may be useful. I don't know how I'm going to remove the rust or put down enamel because it's a very tight tolerance - I can barely slip a paper towel into it to try to dry it.Īnyone have any experience or recommendations with this? I think a good way forward is to dry the rusty area out, remove the rust (CLR?), try to put down some enamel with an enamel repair kit, then recaulk it. ![]() I'm looking through home repair/maintenance websites and DIY websites too, but I'm continually impressed by the wealth of knowledge that the Bogleheads possess. If at all possible, I'm looking to do this myself. I'm looking for a good way to move forward with this that does not involve replacing the bath tub. Our caulk in the shower tub started "rusting." I removed the caulk this morning and found that it's bare metal beneath the caulk, and on the seam on the showerhead/spout side, it's bare metal with a helpful coat of rust.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |